Once your own greenhouse gardening a dream of many gardeners. Imagine yourself in a position by its own garden full of herbs and vegetables and beautiful plants protected from the elements and go roving destructive insects and animals. If you have a "green thumb" This could be your idea of heaven and construction, is not difficult, which makes this an attractive project to get into.
Building a greenhouse requires first an adequate amount of room, at least 10 meters of 20Meter is a good size, but you can go much higher if you choose. The more compact which is cheaper and easier, of course, but if you prefer, you can always a little green house DIY kit, but the restrictions are very restrictive.
Next, you need your materials:
Wooden poles to construct doors and frames for each end, and if a fairly large greenhouse, more may need to rely on the roof. A strong end structure and robust design for inner city are of crucial importance. Make sure that theWood is, however, be treated as it can get quite humid and you do not want it to rot.
-6mm clear plastic, enough to cover the entire area of your greenhouse. Getting more than you need is in order, as you need replacement parts for some time goes on.
Enough PVC pipe to the structure for the green house like a rib cage curving from the ground to create a page to another. This is done in pieces not one long piece.
Metal rods, this is for hammering into the ground for asolid base for your PVC piping which then slide on to keep it in position.
Tape, an essential part of any craftsman's kit! You need to put together a good bit of that use into pieces.
Hammer, nails and so on
Although you may have a few other little things This is the main structure for your greenhouse. You need to use the wood for the doors and ends of the greenhouse gases that they are well by hammering them deep into the round, or it is erected to providesome wooden poles supporting the structure at an angle of 45 degrees from the frame.
You then need the metal stakes into the ground at even intervals between the frames keeping them about 2 meters apart is about right hammer. The metal rods have line-up on the left and right, of course.
When the stakes are, you can the PVC pipes to the metal inserts to give the PVC a good solid structure at the bottom slot can hold it until your roof. Bend the PVC piping as much as youcan, so it makes a U-shape over the top, where the green house and slide the other end into the metal match on the other side.
This may mean you need to cut the PVC into smaller parts and use some small PVC flexible joiners you can buy from any hardware store.
By now you should have a framework for them and quite a study book. Now you need to put the plastic cover above the green house. This can be difficult and you may need to adjust cutting lengths, but with yourMeasuring tape, and you also be able to create a cover for the whole structure and keep it in place with duct tape or even by plastic ties if you should choose, the cover to be attached to each piece of structure, that there is no movement. Do not forget, a door in the cover and cut!
The lid is in force on the ground by good duct tape or pipe through a large, heavy stones instead, some have used tent pegs to get it tied to the ground, but what works best for you.
You now haveYou can create your own, and can in all the extras you need to get your green house nursery tend to bring!
rehab
Continuar leyendo 
Ocultar articulo 
